Fastener Tightening Specifications

Upper Control Arm Ball Joint Stud Nut 20 Nm (15 lb ft) + 250 degrees.
Upper Control Arm Mounting Bolts 110 Nm (81 lb ft)
Outer Tie Rod End Jam Nut 60 Nm (44 lb ft)
Rear Crossmember Mounting Nuts (Use New Nuts) 110 Nm (81 lb ft)
Rear Spring Anchor Plate Bolts 65 Nm (49 lb ft)
Shock Absorber Lower Mounting Bolts 220 Nm (162 lb ft)
Shock Absorber Upper Mounting Nut 29.5 Nm (22 lb ft)
Stabilizer Shaft Insulator (Lower) Clamp Bolts 95 Nm (70 lb ft)
Stabilizer Shaft Insulator (Upper) Clamp Bolts 65 Nm (49 lb ft)
Stabilizer Shaft Link Nuts 72 Nm (53 lb ft)
Tie Rod Nut:
1. Tighten the nut to 20 Nm (15 lb ft) to seat the tie rod stud.
2. Turn the nut an additional 2 1/2 flats.
3. Check the tie rod end nut for a minimum torque of 45 Nm (33 lb ft).
Tie Rod Nut To Crossmember 80 Nm (59 lb ft)
Transverse Leaf Spring Anchor Bolts 50 Nm (37 lb ft)
Lower Control Arm (Rear) Cam Bolts 95 Nm (70 lb ft)
Lower Control Arm Ball Joint Stud Nut 30 Nm (22 lb ft) + 180 degrees.
Wheel Hub Mounting Bolts 95 Nm (70 lb ft)
Lower Control Arm (Front) Cam Bolts 145 Nm (107 lb ft)