Anaerobic Sealer
DESCRIPTIONAnaerobic gasket eliminator hardens in the absence of air. This type sealer is used where two rigid parts (such as castings) are assembled together. When two rigid parts are disassembled and no sealer or gasket is readily noticeable, the parts were probably assembled using a gasket eliminator.
NOTE: Follow all safety recommendations and directions that are on the container.
OPERATION
Apply a continuous bead of gasket eliminator to one flange. Surfaces to be resealed must be clean and dry. Spread the sealer evenly with your finger to get a uniform coating on the sealing surface. Do not allow the sealer to enter any blind threaded holes, as it may prevent the bolt from clamping properly or cause damage when tightened. Tighten bolts to specifications. Do not overtighten. After properly tightening the fasteners, remove the excess sealer from the outside of the joint.
NOTE: Anaerobic sealed joints that are partially torqued and allowed to cure more than five minutes may result in incorrect shimming and sealing of the joint.
CAUTION: Do not allow the sealer to enter any blind threaded holes, as it may prevent the bolt from seating properly or cause damage when the bolt is tightened.