Wiper Motor Linkage: Service and Repair

Remove or Disconnect
Tool Required:
J 39232 Wiper Linkage Separator
1. Wiper arm and blade assemblies.
2. LH cowl panel and hood seal.
3. Washer hose assembly (11) from LH cowl panel.
4. Water shield (21).
5. Screw (14) and nut (20).
6. Socket of RH linkage assembly (13) from ball of LH linkage assembly (15) using J 39232.
7. LH linkage assembly.
8. Three screws (12).
9. Socket of RH linkage assembly from crank arm ball of wiper motor assembly (17) using J 39232.
10. RH linkage assembly from slotted plenum access hole.

Install or Connect
Tool Required:
J 39529 Wiper Linkage installer.

NOTICE: Refer to Service Precautions / Vehicle Damage Warnings / Fastener Requirements.

1. RH linkage assembly (13) through slotted plenum access hole.
2. Three screws (12) finger tight.
3. Align RH linkage assembly.
4. Press socket of RH linkage assembly into engagement With crank arm ball of wiper motor assembly (17) using J 39529.
5. LH linkage assembly (15) without attaching parts.
6. Press socket of RH linkage assembly into engagement with ball of LH linkage assembly using J 39529.
7. Screw (14) and nut (20)
Tighten
- Screw (14) nut (20) and three screws (12) to 10 Nm (7.5 lb ft).
8. Water shield (21) on LH linkage assembly (15).
- Insert the flat side of the water shield under the windshield.
9. Washer hose assembly to LH cowl panel and washer nozzle (10).
10. LH cowl panel and hood seal.
11. Wiper arm and blade assemblies.