Transmission Mount: Service and Repair

REMOVE OR DISCONNECT
1. Raise and suitably support vehicle.
2. Support manual transmission (1 or 2) with transmission stand.
3. Transmission runout nut (16) and washer (17) from transmission mount (13).
4. Transmission support bolts/screws (15) from rail.
5. Transmission support (14).
6. Transmission mount bolts/screws (18) from manual transmission (1 or 2).
7. Transmission mount (13).

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the correct location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHER WISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on the threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Transmission mount (13) to manual transmission (1 or 2).
2. Transmission mount bolts/screws (18).

Tighten
Transmission mount bolts/screws (18) to 48 Nm (36 ft. lbs.).

3. Transmission support (14) to rails.
4. Transmission support bolts/screws (15).

Tighten
Transmission support bolts/screws (15) to 57 Nm (43 ft. lbs.).

5. Transmission mount washer (17) and nut (16).

Tighten
Transmission mount nut (16) to 57 Nm (43 ft. lbs.).

6. Remove transmission stand supporting manual transmission (1 or 2).
7. Lower vehicle.