Manual Transmission Control Lever Boot

REMOVE OR DISCONNECT

1. Front floor console trim plate.
2. Handle bolts/screws (27).
3. Handle (26).
4. Boot bolts/screws (22 or 23).
5. Boot (24 or 25) from front compartment floor pan (44 or 51).

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the correct location. When you replace a fastener, use ONLY to exact part number for that application. The Manufacturer will call out those fasteners that require a replacemet after removal. The Manufacturer will also call out the fasteners that require thread lockers or thread Seal UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastens torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts an systems.

1. Boot (24 or 25) to front compartment floor pan (44 or 51).
2. Boot bolts/screws (22 or 23).

Tighten
Boot bolts/screws (22 or 23) to 1.7 Nm (15 inch lbs.).

3. Handle (26) to control (20).
4. Handle bolts/screws (27).

Tighten
Handle bolts/screws (27) to 25 Nm (18 ft. lbs.).

5. Front floor console trim plate.