G. Transmission Adapter Plate

^ Tools Required:
- J 23907 Slide Hammer
- J 39439-2 Bushing Remover
- J 39433 Input Shaft Seal Installer
- J 39437 Bushing Installer

DISASSEMBLE
1. Input shaft bearing race (8) and shim (7).
2. Countershaft bearing race (103) and shim (102).
3. Adapter plate plug (2).
4. Input shaft seal (6).

Important
- Do not replace bushing (5) unless inspection shows bushing damage.

5. 1st/2nd, 3rd/4th shift rail bushing (5) using J 23907 and J 39439-2.
6. Dowel pins (3 and 4).

Clean
- Adapter plate components with solvent and dry with compressed air.

Inspect
Adapter plate components.
- Bearing races (8 and 103) and bores for wear, scratches or grooves.
- Bushing (5) for excessive wear or burrs. Replace if this condition exists.
- Case for cracks, sealing surfaces for nicks, burrs or scratches. If case is cracked, it must be replaced.

NOTICE: If scuffed, nicked, burred or scoring conditions cannot be reconditioned by hand with a soft stone or crocus cloth, replace the component.

ASSEMBLE
1. Dowel pins (3 and 4).
2. 1st/2nd, 3rd/4th, shift rail bushing (5) using J 39437.
3. Input shaft seal (6) using J 39433.