Lower

Inspect:
1. Raise vehicle and position floor stands under both lower control arms as near as possible to each ball stud.

Important:
^ Vehicle must be stable and should not rock on floor stands.
^ Wipe the ball joints clean and check the seal for cut or tears. If the seal is cut or torn, the ball joint MUST be replaced.

2. Position dial indicator against wheel rim.
3. Pry between the lower control arm and the steering knuckle while reading the dial indicator. Vertical deflection on the dial indicator should not exceed 1.19 mm (0.046875 inch).
^ If dial indicator reading exceeds 1.19 mm (0.046875 inch), replace ball stud.
4. Anytime ball stud is disconnected from steering knuckle, check for looseness or if ball stud can be twisted in its socket with your fingers. If either of these conditions exist, replace ball stud.
5. Lower vehicle.