Flushing Preparation

NOTE: Do not place your foot on the brake pedal through this entire procedure unless specifically directed to do so.

1. Remove foot from brake pedal.
2. Start engine and allow it to run for at least 10 seconds while observing the amber ABS warning lamp.
3. If the amber ABS warning lamps turned "ON" and stayed "ON" after about 10 seconds, the flushing procedure must be stopped and a Tech 1 must be used to diagnose the ABS malfunction.
4. If the amber ABS warning lamps turned "ON" for approximately 3 seconds, then turned "OFF" and stayed "OFF," turn the ignition "OFF."
5. Repeat steps 1 through 4 one more time.
6. The entire brake system should now be flushed.