Accelerator Pedal Replacement

REMOVE OR DISCONNECT

1. Lower instrument panel trim.
2. Sound insulator.
3. Accelerator cable from accelerator pedal.
4. Accelerator pedal attaching nut.
5. Accelerator pedal stop attaching bolt and accelerator pedal stop.
6. Accelerator pedal.

INSTALL OR CONNECT

CAUTION: The mounting surface between support and dash panel must be free of insulation. The carpet and padding in the pedal and tunnel area must be positioned to lay flat and be free of wrinkles and bunches.

1. Accelerator pedal and attaching nut.
2. Accelerator pedal stop and attaching bolt. Tighten pedal stop and attaching nut and bolt to 25 Nm (18 ft.lb.).
3. Accelerator cable on accelerator pedal.

NOTE: Check for complete throttle opening and closing positions by operating accelerator pedal. Also check for proper carpet fit under the accelerator pedal. Throttle should operate freely without bind between full closed and wide open throttle.

4. Sound insulator.
5. Lower instrument panel trim.