Case: Service and Repair

REMOVE OR DISCONNECT
1. Raise and suitably support vehicle.
2. Support transmission using transmission jack.
3. Transmission support.
4. Lower transmission.
5. Ventilation hose (18) from ventilation tube (20) at transmission (838).
6. Ventilation hose clip (19) from transmission support (850).
- Squeeze clip tabs to remove from holes in transmission support (850).

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the correct location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHER WISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on the threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. New ventilation hose clip (19) around ventilation hose (18) 37 mm from end of hose.
2. Ventilation hose clip (19) into holes at rear side of transmission support (850).
3. Ventilation hose (18) to ventilation tube (20) at transmission (838).
4. Raise transmission.
5. Transmission support.
6. Support from transmission.
7. Lower vehicle.