Wheel Stud / Lug Nut: Service and Repair

^ Tool Required:
- J 6627-A Wheel Stud Remover
- Or Equivalent

REMOVE OR DISCONNECT

NOTICE: Do not damage wheel mounting surface on hub flange. Brake disc must be supported before pressing wheel bolt in or out.

^ Hub or disc bolts, using J 6627-A.

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the correct location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

^ New serrated bolt into hole in hub. Tap lightly with hammer to start bolt serration in hole, making sure that bolt is square with hub flange.