Heated Oxygen Sensor (Bank 2) Replacement

Right Hand Side Of Engine:

Bank 2 Heated Oxygen Sensor Replacement

Notice: The Heated Oxygen Sensors each use a permanently attached pigtail and connector. This pigtail should not be removed from the heated oxygen sensor. Damage or removal of the pigtail or connector could affect proper operation of the heated oxygen sensor.

Important: Take care when handling the heated oxygen sensor. The in-line electrical connector and louvered end must be kept free of grease, dirt or other contaminants. Also, avoid using cleaning solvents of any type. Do not drop or roughly handle the heated oxygen sensor/catalyst monitor. A dropped sensor is a bad sensor.

Removal Procedure

Caution: The heated oxygen sensor may be difficult to remove when engine temperature is below 48°C (120°F). Excessive force may damage threads in exhaust manifold or exhaust pipe. It may be necessary to lower the exhaust system to gain sufficient access to an HO2S and/or its connector. Refer to Exhaust System / Service and Repair.

1. Disconnect the HO2S electrical connector.
2. Carefully back out the heated oxygen sensor.

Installation Procedure

Important: A special anti-seize compound is used on the heated oxygen sensor threads. The compound consists of graphite suspended in fluid and glass beads. The graphite will burn away, but the glass beads will remain, making the sensor easier to remove. New or service sensors will already have the compound applied to the threads. If a sensor is removed from an engine and if for any reason is to be reinstalled, the threads must have anti-seize compound applied before reinstallation.

1. Coat the threads of the heated oxygen sensor with anti-seize compound P/N 12377953, or equivalent if necessary.
2. Install the heated oxygen sensor. Tighten the HO2S to 41 Nm (30 lb ft).
3. Connect the HO2S electrical connector.