Wiring Harness

REPLACE
1. Disconnect battery ground cable.
2. Remove left rear storage compartment cover.
3. On Coupe models, disconnect EBTCM wiring harness electrical connector.
4. On Convertible models, proceed as follows:
a. Remove EBTCM attaching nut.
b. Pull connector retaining clip to release front of connector.
c. Push retaining clip back down without locking front of connector.
d. Push EBTCM toward front of vehicle as possible.
e. Lift front of connector to release connector rear.
5. On models equipped with Selective Ride Control, disconnect selective ride control module electrical connector.
6. Disconnect wheel speed sensor electrical connectors.
7. On models equipped with Selective Ride Control, disconnect selective ride control actuator electrical connector.
8. Disconnect body harness connector.
9. Remove modulator valve cover.
10. Disconnect modulator valve electrical connector.
11. Remove wiring harness, noting harness routing.
12. Reverse procedure to install, noting the following:
a. Ensure all connectors are tight and fully seated.
b. Ensure EBTCM connector retaining clip is locked.