Part 1

LOCK HOUSING COVER, COVER END CAP, DIMMER SWITCH ROD ACTUATOR & TILT SPRING

DISASSEMBLE
1. Remove lock housing cover attaching screws and the cover, then the tilt lever.
2. Remove cover housing end cap, then dimmer switch rod actuator.
3. Using a cross recess head screwdriver, remove spring retainer. Push retainer down and turn counterclockwise to release.
4. Remove spring and spring guide.

ASSEMBLE
NOTE: Ensure all fasteners are securely seated before applying required torque.
1. Coat spring guide and spring with lithium grease and install them, then install spring retainer. Push retainer down and turn clockwise to lock into place.
2. Install dimmer switch rod actuator to dimmer switch rod.
3. Install cover housing end cap.
4. Install lock housing cover. Tighten screw in 12 o'clock position first, screw in 8 o'clock position second and screw in 3 o'clock position third, then torque screws to 80 lb in in same order.