P1870

Diagnostic Chart:

Wiring Diagram:

CIRCUIT DESCRIPTION

The PCM monitors the difference between the engine speed and the transmission output speed. In D3 drive range with the TCC engaged, the engine speed should closely match the transmission output speed. In D4 drive range with the TCC engaged, the TCC slip speed should be -20 to +20 RPM.

When the PCM detects excessive TCC slip when the TCC should be engaged, then DTC P1870 sets. DTC P1870 is a type A DTC.

CONDITIONS FOR SETTING THE DTC

The following conditions are met for three TCC cycles with reported excessive TCC slip conditions:

^ No TP DTCs P0122 or P0123

^ No Vehicle Speed Sensor (VSS) DTC P050

^ No TPT sensor DTCs P0712 or P0173

^ No 1-2 SS Valve DTCs P0751 or P0753

^ No 2-3 SS Valve DTCs P0756 or P0758

^ No TFP Valve Position Switch DTC P1810

^ No TCC PWM Solenoid Valve DTC P1860

^ No TCC Solenoid Valve DTC P1864

^ The engine speed is less than 5500 RPM.

^ The engine vacuum is between 35 and 70 kPa. (10.4-20.7 in Hg).

^ The gear range is D4.

^ Not in 1st gear

^ The TP angle is between 13 and 36%.

^ The Transmission Fluid Temperature (TFT) is between 20 and 130°C (68 and 266°F).

^ The TCC is ON for greater than 0.1 second.

^ The TCC is at maximum apply for 0.1 second.

^ The Shift Solenoid performance counter is zero.

^ The TCC slip speed is greater than 130 RPM for greater than 8 seconds.

ACTION TAKEN WHEN THE DTC SETS

^ Inhibit TCC engagement

^ Maximum line pressure

^ Inhibit 4th gear if in hot mode

^ The freeze shift adapts from being updated.

^ The PCM illuminates the Malfunction Indicator Lamp (MIL).

CONDITIONS FOR CLEARING THE DTC

^ The PCM turns OFF the MIL after three consecutive ignition cycles without a failure reported.

^ A scan tool can clear the DTC from the PCM history. The PCM clears the DTC from the PCM history if the vehicle completes 40 warm-up cycles without a failure reported.

^ The PCM cancels the DTC default actions when the fault no longer exists and the ignition is OFF long enough in order to power down the PCM.

DIAGNOSTIC AIDS

^ A TFP Valve Position Switch malfunction could set DTC P1870.

^ The following mechanical conditions could set DTC P1870:

- A mechanical failure of the shift solenoid valves

- A mechanical failure of the TCC Solenoid Valve

- A mechanical failure of the TCC PWM Solenoid Valve

^ Internal transmission failures may set a DTC P1870.

^ An engine, misfire may erroneously set a DTC P1870.

^ Ensure that the final drive ratio matches the PCM's calibration.

^ A PRNDL DTC may falsely set DTC P1870. Refer to 4L60-E Shift Speed Chart.

TEST DESCRIPTION

The numbers below refer to the step numbers on the diagnostic chart.

2. This Step compares the indicated range signal to the actual selected range. A faulty TFP Valve Position Switch could set a DTC P1870.

3. This Step tests for slippage while the torque converter is in a commanded lock-up state.