Alternator Rear Brace

Generator Mounting.:

REMOVE OR DISCONNECT
1. Negative battery cable.
2. Raise vehicle and suitably Support.
3. Generator rear brace retaining bolt and nut, including cooling duct bracket.
4. Generator rear brace.

INSTALL OR CONNECT
1. Generator rear brace.
2. Generator rear brace retaining bolt and nut, including cooling duct bracket.
^ Parts should fit easily. Tightening bolts and nuts MUST NOT put generator assembly in a bind.

Tighten
^ Generator rear brace bolt to 25 Nm (18 ft lb).
^ Generator rear brace nut to 50 Nm (37 ft lb).

3. Lower vehicle.
4. Negative battery cable at battery. Refer to "Idle Learn Procedure". Tighten Cable bolt to 15 Nm (11 ft lb).