Sedan

Door Trim Panel:

Tools Required:
J 24595-C Door Trim Pad and Garnish Clip Remover

Remove or Disconnect

1. Trim cover.
2. Screw from underneath trim cover if coupe.
3. Retractor cover.
4. Door trim plate.
5. Power window switch assembly, if present.
6. Window regulator handle, if present.
7. Screw and inside handle bezel if sedan.
8. Remote mirror control, if present.
9. Upper trim panel screw, if sedan.
10. Screws.
11. Door trim panel using J 24595-C to disengage fasteners from holes in door inner panel.

Install or Connect

1. Wire hamesses, if present, through openings in trim panel.
2. Trim panel to door by aligning fasteners on trim panel to holes in door inner panel and pressing trim panel to door until fasteners are fully engaged.
3. Screws.

Tighten
^ ^ Screws to 2 N.m (18 lb in).

4. Upper trim panel screw, if sedan.

Tighten
^ Screw to 1.6 N.m (14 lb in).

5. Remote mirror control, if removed.
6. Inside handle bezel and screw if sedan.

Tighten
^ Screw to 1 N.m (9 lb in).

7. Window regulator handle, if removed.
8. Power window switch assembly, if removed.
9. Door trim plate.
10. Retractor cover.
11. Screw to trim cover opening.

Tighten
^ Screw to 1 N.m (9 lb in).

12. Trim cover.