Harmonic Balancer - Crankshaft Pulley: Service and Repair

Fig. 10 Exploded View Of Cylinder Block Assembly:

REMOVAL
Refer to Fig. 10, when performing the following any procedures.
1. Disconnect battery ground cable.
2. Remove serpentine belt, then raise and support vehicle.
3. Remove wheel and tire assembly, then inner fender splash shield.
4. Remove three crankshaft pulley retaining bolts.
5. Remove crankshaft pulley hub bolt, then the crankshaft pulley.
6. Install crankshaft pulley puller tool No. J 24420-B or equivalent on hub.
7. Turn puller screw and remove hub.

INSTALLATION
1. Coat front cover seal contact area with engine oil.
2. Apply RTV sealer No. 1052917 or equivalent, to keyway in pulley hub.
3. Place crankshaft pulley hub into position over key on crankshaft.
4. Install crankshaft pulley installer No. J 29113 into crankshaft so that at least 1/4 inch of thread is engaged.
5. Pull pulley hub into position and remove tool from crankshaft.
6. Install crankshaft pulley, then three pulley retaining bolts.
7. Install inner slash shield, then wheel and tire assembly.
8. Lower vehicle and install serpentine belt.
9. Connect battery ground cable.