Rough, Unstable, or Incorrect Idle, Stalling

SYMPTOM DESCRIPTION:
The engine runs unevenly at idle. If bad enough, the vehicle may shake. Also, the idle may vary in rpm (called "hunting"). Either condition may be severe enough to cause stalling. Engine idles at incorrect speed.




SYSTEM OR COMPONENT TO CHECK ACTION

COMPUTER INPUTS/OUTPUTS CHECK: ^ OXYGEN SENSOR (O2) - Inspect sensor for
silicon contamination from fuel, or use of
improper RTV sealant. The sensor will have
a white, powdery coating, and will result
in a high but false signal voltage (rich
exhaust indication). The ECM/PCM will then
reduce the amount of fuel delivered to the
engine, causing a severe driveability
problem.
^ THROTTLE POSITION SENSOR (TPS) - If a
sticking throttle shaft or binding linkage
causes a high TPS voltage.
A "Scan" tool and/or voltmeter should read
less than 1.25 volts with throttle closed.
^ COOLANT TEMPERATURE SENSOR (CTS) - Using
a "Scan" tool compare coolant temperature
with ambient temperature on a cold engine.
If coolant temperature reads 5 degrees
greater than or less than ambient air
temperature. Check for high resistance
in coolant sensor circuit or sensor itself.
Compare resistance value to chart.
DTC 15
^ MANIFOLD ABSOLUTE PRESSURE (MAP)
Sensor response and accuracy.
Chart C-1D Manifold Absolute Pressure (MAP) Output Check
^ ECM/PCM grounds for being clean,
tight, and in their proper location.
^ IAC operation.
Chart C-2C Idle Air Control (IAC) System Check
^ P/N switch circuit.

NOTE: ^ Use "Scan" tool to determine if ECM is
receiving A/C request signal whenever
A/C is selected.
Chart C-10 A/C Clutch Control Circuit Diagnosis
If problem exists with A/C "ON," check A/C
system operation.







FUEL NOTE: ^ To determine if the condition is caused
by a rich or lean system, the vehicle should be
driven at the speed of the complaint.
Monitoring block learn will help identify problem.
LEAN: Block learn more than 150.
DTC 44.
RICH: Block learn less than 115.
DTC 45
CHECK: ^ FUEL PRESSURE:
[1][2]Chart A-7 Fuel System Diagnosis




IGNITION CHECK: ^ SECONDARY AND PRIMARY SYSTEM.
^ For DIS/EST operation or misfire,
[1][2]C Charts
Check ignition wires for shorts or faulty insulation.





EMISSIONS CHECK: ^ EVAPORATIVE SYSTEM.
^ EGR SYSTEM "ON," while idling, will cause
roughness, stalling and hard starting.
^ PCV VALVE for proper operation by placing finger
over inlet hole in valve end several times.
Valve should snap back. If not, replace valve.
^ AIR MANAGEMENT SYSTEM.
NOTE: ^ Refer to EMISSION CONTROLS
for complete testing procedures.




ENGINE CHECK: ^ VACUUM LEAKS can cause higher
than normal idle and low IAC counts.
^ BATTERY cables and ground straps should be
clean and secure.
Erratic voltage will cause IAC to change its
position, resulting in poor idle quality.
IAC valve will not move, if system voltage
is below 9 or greater than 16 volts.
^ A/C refrigerant pressure too high,
overcharge or faulty high pressure switch.
^ MOTOR MOUNTS.
^ CYLINDER COMPRESSION.