Shift Solenoid: Service and Repair

1. Disconnect negative battery cable.

2. Raise and support vehicle.

3. On convertible models, remove upper and lower underbody braces.

4. On all models, disconnect exhaust system and if necessary, remove driveline support beam, then the propeller shaft.

5. Remove two oil pan bolts, then install servo cover compressor tool No. J-29714 or equivalent on oil pan flange and depress servo cover.

6. Remove servo cover retaining ring.

7. Remove servo cover and seal ring.

8. Remove servo piston and bore-apply pin assembly.

9. Reverse procedure to install. Whenever any servo parts are replaced, apply-pin length must be checked.