Wiper Transmission

Wiper Transmission

Fig 11: Wiper Transmission (Typical):

Remove or Disconnect

1. Raise hood.
2. Right and left wiper arm and blade assemblies.
3. Loosen (do no remove) attaching nuts securing transmission drive link(s) to motor crank arm.
4. Air inlet screw/panel.
5. Transmission drive link(s) from the motor crank arm.
6. Transmission-to-body attaching screws.
7. Transmission and linkage assembly by guiding it through access hole in shroud upper panel.

Install or Connect

1. To install transmission and linkage assembly, position assembly in plenum chamber through the shroud upper panel openings.
2. Loosely install transmission to body attaching screws.
3. Transmission drive link to motor crank arm and tighten attaching nuts to 7Nm (64 lbs in).
4. Align transmission and tighten attaching screws to body.
5. Air inlet screen/panel.
6. Wiper arm and blade assemblies and adjust as described under "Wiper Arm Adjustment" Adjustments.
7. Check wiper operation, wipe pattern and park position.
8. Cowl vent screen or cowl upper panel and screen.
9. Check washer nozzle alignment.