Service Procedure

Figure 1 - EVAPORATIVE CANISTER ASSEMBLY:

1. Remove air cleaner cover.

2. Locate fuel tank evaporative canister - attached to left hand side of dash upper panel underhood. Cut canister vent hose approximately 3.0 in. (76 mm) below base of canister (See figure 1).

3. Attach "T" connector P/N 94440909 (part of kit) to canister vent hose as shown (See figure 1).

Figure 2 - FUEL PUMP ASSEMBLY:

Figure 3 - FUEL PUMP:

4. Connect molded end of fuel pump ventilation hose P/N 94441488 (part of kit) to fuel pump vent pipe as shown (See Figure 2). Figure 3 shows vent pipe location for the two configurations of fuel pumps.

Figure 1 - EVAPORATIVE CANISTER ASSEMBLY:

5. Attach clip P/N 94403123 (part of kit) to rear engine mount strut. Connect ventilation hose to "T" connector at canister vent hose and secure fuel pump vent hose to clip as shown (See figure 1).

6. Install Campaign Identification Label.

CAMPAIGN IDENTIFICATION LABEL:

CAMPAIGN IDENTIFICATION LABEL

Each vehicle modified in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label." Each label provides a space to include the five digit dealer code of the dealer performing the campaign service. This information may be inserted with a typewriter or ball point pen.
Each "Campaign Identification Label" is to be located on the radiator core support in an area which will visible when the vehicle is brought in for periodic servicing by the owner.

Apply "Campaign Identification Label" only on a clean dry surface.