Removal and Installation

1. Disconnect negative battery cable.

2. Remove air inlet tube.

3. Disconnect speedometer cable.

4. Disconnect thermostat housing at transaxle.

5. Disconnect ground wire at transaxle.

6. Disconnect clutch slave cylinder and lay aside.

7. Disconnect clutch cables (4 clips).

8. Disconnect backup light switch.

9. Remove (2) upper bellhousing bolts.

10. Remove transaxle mount upper bolt.

11. Install engine support tool.

12. Raise vehicle.

13. Remove L/H wheel.

14. Remove left splash shield.

15. Remove right splash shield.

16. Remove center splash shield.

17. Remove center beam.

18. Remove inspection cover.

19. Disconnect L/H lower control arm at spindle.

20. Disconnect R/H lower control arm at spindle.

21. Disconnect right and left axle shafts at transaxle.

22. Disconnect both starter bolts.

23. Support transaxle.

24. Remove (3) backside transaxle to engine bolts.

25. Remove (1) remaining bolt.

26. Reverse procedure to install.