Drivetrain - Driveline Squeaking At Low Speeds Repair
85-1124B
AUG., 1985
Subject: DRIVELINE "SQUEAKING" NOISE
Model and Year: 1984-85 CHEVETTE
TO: ALL CHEVROLET DEALERS
Some 1984-85 Chevettes may exhibit a "squeaking" noise at low speeds coming from the rear of the vehicle.
FIGURE 1.:
This condition has been determined to be the result of improperly seated differential stem pinion gear thrust caps contacting the polyurethane bumper of the rear axle extension assembly (See Illustration).
Vehicles exhibiting this condition can be repaired by replacing the thrust cap polyurethane bumper and applying a powder graphite to the thrust cap face following procedures below:
1. Remove rear axle extension assembly from vehicle following applicable procedure in 1984-85 Chevette Shop Manual.
2. Remove thrust cap from stem pinion gear and discard.
3. Inspect chamfer on end of stem pinion gear. Clean up as required utilizing a file to insure chamfer is uniform and no burrs are present.
4. Position new thrust cap, P/N 8932649, on end of stem pinion gear. With concave end of tool J-29194, steering linkage installer, against thrust cap face, drive cap onto stem pinion gear.
NOTICE: A properly seated thrust cap will visually appear to run parallel to the stem pinion gear but not when rear wheel is rotated.
5. Secure rear axle extension assembly in vise. Drill 1/8" holes around the circumference of the polyurethane bumper to aid in bumper removal. Remove bumper and thrust plate utilizing suitable pick.
6. Clean all debris from splined bore of extension shaft.
7. Install removed thrust plate and new bumper, P/N 459797, into extension shaft insuring that bumper surface with mold marks and numbers are facing inboard. With appropriate size socket and hammer, seat bumper in extension shaft counterbore.
8. Apply a light film of oil to thrust cap face. Dust cap face with a liberal amount of powder graphite such as Panef Quality Dry Graphite Lubricant or equivalent.
9. Install extension housing assembly following applicable procedure in 1984-85 Chevette Shop Manual
Labor Operation Number: T1138
Labor Time: .8 hours