Camshaft Cover Replacement - Right

Camshaft Cover Replacement - Right

Removal Procedure





1. Remove the fuel injector sight shield.
2. Remove the secondary air injection (AIR) check valve.
3. Disconnect the positive crankcase ventilation (PCV) foul air tube quick connect fitting from the camshaft cover.
4. Remove the ignition coils.





5. Loosen the camshaft cover bolts.
6. Remove the camshaft cover.
7. Discard the camshaft cover perimeter seals and spark plug seals if there is any evidence of damage or if the seal comes out of the groove in the cover during removal.
8. Clean and inspect the camshaft cover.

Installation Procedure





Important: Be careful to prevent the exposed section of the camshaft cover seal from being damaged by the edge of the cylinder head casting.

1. Install the camshaft cover seal as required.
2. Install the camshaft cover.

Notice: Refer to Fastener Notice in Service Precautions.

3. Tighten the camshaft cover bolts.
Tighten the bolts to 10 Nm (89 inch lbs.).
4. Install the ignition coils.





5. Connect the PCV foul air tube quick connect fitting to the camshaft cover.
6. Install the AIR check valve.
7. Install the fuel injector sight shield.