Ignition Coil: Service and Repair

Ignition Coil:

Ignition Coil And Ignition Control Module:

IGNITION COIL AND IGNITION CONTROL MODULE

NOTE: Numbers included in this procedure refer to caption numbers in the accompanying images.

DISASSEMBLE
1. Coil (10) from brackets (13 and 14) by drilling out rivets (9).
2. Bolts/screws (12).
3. Ignition control module (11).

ASSEMBLE

NOTE: A package of silicone grease is included with a new ignition control module. This grease is necessary for ignition control module cooling.

1. Spread silicone grease on metal face of ignition control module (11) and on bracket (13) where it seats, and position ignition control module (11) to bracket (13).
2. Bolts/screws (12). Tighten bolts/screws (12) to 1.7 Nm (15 lb in).
3. Coil (10) to brackets (13 and 14) using bolts/screws provided with replacement coil (10). Tighten bolts/screws to 2.8 Nm (25 lb in).