Closeout/Insulator Panel Replacement - Right

CLOSEOUT/INSULATOR PANEL REPLACEMENT - RIGHT

REMOVAL PROCEDURE




1. Remove the four screws securing the closeout panel to the I/P.
2. Pull down on the panel in order to release the locking tabs (1).
3. Disconnect the courtesy lamp electrical connector.
4. Remove the closeout panel from the I/P.

INSTALLATION PROCEDURE




1. Connect the courtesy lamp electrical connector.
2. Align the closeout panel on the I/P.
3. Push upward on the panel in order to secure the locking tabs (1).

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the closeout retaining screws.

Tighten the fasteners to 2 N.m (18 lb in).