Canister Purge Solenoid: Service and Repair

Evaporative Emission Canister Purge Solenoid Valve Replacement

Removal Procedure






Important: The evaporative emission (EVAP) purge valve is located on the upper intake manifold.

1. Remove the fuel injector sight shield
2. Disconnect the EVAP canister purge valve purge pipe (2).
3. Disconnect the EVAP canister purge valve electrical connector.




4. Remove the EVAP purge valve bolt (2).
5. Remove the EVAP purge valve (3).

Installation Procedure




1. Install the EVAP purge valve (3).

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the EVAP purge valve bolt (2).

Tighten the bolt to 12 N.m (106 lb in).

3. Connect the EVAP canister purge valve electrical connector.




4. Connect the EVAP canister purge valve purge pipe (2).
5. Install the fuel injector sight shield.