Brake Rotor Replacement

REMOVAL PROCEDURE
1. Remove the tire and wheel assembly.
2. Remove the brake caliper support assembly from the knuckle, support the caliper assembly away from the rotor.
3. Remove the brake rotor.

INSTALLATION PROCEDURE

IMPORTANT: Whenever the rotor has been separated from the wheel bearing flange, clean any rust or contaminants from the wheel bearing flange and the brake rotor mating surfaces. Failure to do this may result in increased lateral runout of the rotor, and brake pulsation.

1. Clean the mating surfaces on the rotor and the wheel bearing flange.
2. Install the rotor over the wheel studs onto the wheel bearing flange.
3. Install the brake caliper assembly.
4. Install the tire and wheel assembly.