Turn Signal Flasher: Service and Repair

REMOVAL PROCEDURE
1. Remove the IP assembly.
2. Remove the left side window defogger duct from behind the cluster area of the IP carrier.
3. Remove the flasher module (1) from the bracket. The flasher module is attached on the Lighting Control Module (LCM) bracket under the IP.
4. Remove the flasher module connector.
5. Remove the flasher module (1).

INSTALLATION PROCEDURE
1. Install the connector to the flasher module.
2. Install the flasher module (1) on to the bracket.
3. Install the left side window defogger duct.
4. Install the IP assembly.