Brake Modulator Bracket Replacement

REMOVAL PROCEDURE





1. Turn the Ignition switch to the OFF position.
2. Remove BPMV and EBCM/EBTCM assembly (2) from the BPMV mounting bracket (4).
3. Remove the two BPMV mounting bracket nuts (3) and one bolt located near the bottom and one nut (1) located at the top of the BPMV mounting bracket (4) to the strut tower.
4. Remove the BPMV mounting bracket (4) from the vehicle.

INSTALLATION PROCEDURE





1. Install the BPMV bracket (4) to the strut tower.
2. Install the one bolt and three nuts that attach the BPMV mounting bracket (4) to the strut tower.

^ Tighten the lower two BPMV mounting bracket nuts (3) and bolt to 10 Nm (7 ft. lbs.).
^ Tighten the top nut (1) for BPMV mounting bracket (4) to strut tower to 3 Nm (26 inch lbs.).

3. Install the BPMV and EBCM/EBTCM assembly (2) to the BPMV mounting bracket (4).
4. Turn the ignition switch to the RUN position, engine off.
5. Perform the A Diagnostic System Check - ABS.