Water Pump: Service and Repair

REMOVAL
Remove or Disconnect the following components.
1. Negative cable at the battery.
2. Drain the cooling system.
3. Drive belt.
4. Coolant pump pulley bolts.
5. Coolant pump.

CLEAN
Clean all gasket mating surfaces.

INSTALLATION
Install or Connect the following components.
1. Using a new gasket, install the coolant pump on the engine.
^ Bolts 15 Nm (11 ft. lbs.).
^ Bolts 30 Nm (22 ft. lbs.).
2. Coolant pump pulley bolts.
3. Accessory drive belt.
4. Fill the cooling system.
5. Connect the battery, then start the engine.
6. Check for coolant leaks.