Interlock Solenoid Assembly - Column Shift

REMOVE OR DISCONNECT
1. Do all steps under "REMOVE OR DISCONNECT", refer to UPPER COVER LOWER COVER.
2. Two tapping screws (30) from bottom of bearing & housing assembly (11).
3. Interlock solenoid assembly (29) from column.
4. Electrical connector from turn signal & multifunction switch assembly (32) wire harness.

INSTALL OR CONNECT

CAUTION: Refer to CAUTION about fasteners. Failure to do may result in component damage or malfunction of steering column.

1. Interlock solenoid assembly (29) to column.
2. Two tapping screws (30) to bearing & housing assembly (11).
^ Tighten screws (30) to 1.7 Nm (15 lb in).
3. Electrical connector to turn signal & multifunction switch assembly (32) wire harness.
^ Wire strap (31).
4. Do all steps, under "INSTALL OR CONNECT", refer to UPPER COVER AND LOWER COVER.