Brake Pedal Bracket

REMOVE OR DISCONNECT
1. Instrument panel carrier.





2. Brake pedal push rod retaining clip at brake pedal.





3. Brake pedal nut and bolt.
4. Brake pedal.
5. Stoplamp switch.
6. Cruise control switch (if equipped).
7. Wiring harness clips from bracket.
8. Brake pedal bracket upper mounting nuts to cross car beam.
9. Brake pedal bracket upper mounting bolts to cross car beam.
10. Brake pedal bracket lower mounting bolts to reinforcement bracket.
11. Brake pedal bracket.

Inspect
- All parts for wear. Repair or replace as needed.

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.








1. Brake pedal bracket.
2. Brake pedal bracket lower mounting bolts to reinforcement bracket.
- Tighten bolts to 22 Nm (16 ft. lbs.).
3. Brake pedal bracket upper mounting bolts to cross car beam.
- Tighten nuts to 25 Nm (18 ft. lbs.).
4. Brake pedal bracket upper mounting nuts to cross car beam.
- Tighten nuts to 25 Nm (18 ft. lbs.).
5. Wiring harness clips to bracket.
6. Cruise control switch (if equipped).





7. Stoplamp switch.
8. Brake pedal.
9. Brake pedal nut and bolt.
- Tighten nut and bolt to 40 Nm (30 ft. lbs.).
10. Brake pedal push rod retaining clip at brake pedal.
11. Instrument panel carrier.

Adjust
- Stoplamp switch.