Parking Brake Shoe: Adjustments

^ Tool Required:
- J 41713 Drum-To-Brake Shoe Clearance Gage

REMOVE OR DISCONNECT
1. Brake caliper bracket.
2. Rotor.
- Slowly turn rotor while pulling away from hub.
3. Loosen parking brake cable adjusting nut until lever is at its "rest" position.

Adjust
A. Rear parking brake shoe and lining
- Set J 41713 so that it contacts inside diameter of rotor.
- Position J 41713 over shoe and lining at its widest point.
- Turn adjuster nut until shoe and lining just contacts J 41713.
- Repeat procedure for opposite side.
B. Rear parking brake cable. Refer to PARKING BRAKE ADJUSTMENT (DISC OR DRUM). Adjustments

INSTALL OR CONNECT
1. Tighten parking brake cable adjusting nut. Refer to PARKING BRAKE ADJUSTMENT (DISC OR DRUM). Adjustments
2. Rotor.
- Slowly turn rotor while sliding onto bearing assembly.
3. Brake caliper bracket.