- With Standard Column
STEERING WHEEL COIL, SHAFT LOCK, CANCELLING CAM, UPPER BEARING SEAT. INNER RACE, TURN SIGNAL SWITCH, BUZZER SWITCH & LOCK CYLINDERDISASSEMBLE
With steering column, inflator module and steering wheel already removed as previously outlined in Steering Column, proceed as follows:
1. Place key in Lock position.
2. Remove coil assembly retaining ring, slide coil assembly off end of shaft, then remove wave washer.
3. Remove shaft lock retaining ring using compressor tool J-23653-C, or equivalent, to depress shaft lock. Use a 1/2 inch wrench to hold the shaft of pressing tool when releasing the nut.
4. Remove shaft lock and shaft lock cover, then the turn signal cancelling cam.
5. Remove upper bearing spring, then the upper bearing seat.
6. Remove inner race.
7. Place turn signal in right turn position, then remove signal switch arm attaching screw and the arm.
8. Remove turn signal switch attaching screws and position switch out of way. If it is necessary to remove switch, remove wiring harness protector and hazard knob, then gently pull wire harness through gear shift lever bowl, column housing and lock housing cover.
9. If necessary remove coil assembly as follows:
a. Remove connector from terminal connector.
b. Remove wire protector, then attach a wire to the coil assembly connector at the base of the steering column.
c. Pull wire through lock housing cover and gearshift bowl shroud.
10. Remove key from cylinder lock, and remove buzzer switch and clip, then reinsert key in cylinder lock and turn to Lock position.
11. Remove lock retaining screw and lock cylinder set.
ASSEMBLE
1. Install lock cylinder set. Torque retaining screw to 22 lb in
2. Place key in Run position, then install buzzer switch and clip.
3. Route turn signal switch wiring harness through lock housing cover, column housing and gear shift lever bowl.
4. Place coil assembly wire through lock housing cover and gearshift bowl shroud.
5. Connect shroud connector to terminal connector.
6. Install turn signal and hazard warning switch.
7. Install signal switch arm. Torque retaining screw to 20 lb in
8. Install hazard knob, then the inner race.
9. Install upper bearing seat, then the upper bearing spring.
10. Install turn signal cancelling cam, then the shaft lock.
11. Depress shaft lock, then install shaft lock retaining ring.
12. Install steering wheel and inflator module as outlined in Steering Column.