Rocker Arm Cover - Left

REMOVE OR DISCONNECT
1. Negative battery cable.
2. Drain coolant.
3. Ignition wire clamps from coolant tube.
4. Coolant tube mount at head.
5. Coolant tube at each end.
6. Coolant tube hose at water pump.
7. Coolant tube.
8. Tube from Valve cover to air inlet.
9. Ignition wire guide.
10. Valve cover.

CLEAN
^ Sealing surface on cylinder head and valve cover with degreaser.

INSTALL OR CONNECT
1. New gasket and new bolt grommets.
^ Make sure gasket is seated properly in Valve cover groove.
2. Sealer (p/n 1052917) in notch.
3. Rocker arm cover.
Tighten
^ Valve cover bolts to 10 Nm (90 in. lb.).
4. Ignition wire guide.
5. Tube from Valve cover to air inlet.
6. Coolant tube.
7. Coolant tube hose at water pump.
8. Coolant tube at each end.
9. Coolant tube mount at head.
10. Ignition wire clamps at coolant tube.
11. Fill cooling system.
12. Negative battery cable.

INSPECT
^ Proper fluid levels.
^ Leaks.
^ Completion of repair.