Warranty Information
TROUBLEOPERATION NUMBER CODE LABOR OTHER LABOR HOURS
Install V3060 96 .2 Hr. *.1 Hr.
Label
* .1 Hour for Administration
Dealer Buick Owner:
General Motors has determined that some 1984 Centurys have incorrect information on the Vehicle Emission Control Label. These labels state "No Ignition Timing Adjustment." The label should state, "Ignition Timing to be set at 15 Degrees B.T.D.C." The emission label is required by the Federal Clean Air Act.
We have enclosed a new correct Vehicle Emission Control Information Label number 25524875 for your vehicle. You may install this label yourself or take it to a Buick Dealer for installation at no charge to you.
To install the Vehicle Emission Control label yourself, instructions are as follows:
1. Open hood of vehicle and locate the old emission label. (Should be located on the left front strut upper mounting housing.) Refer to illustration.
2. Clean the surface of the old label with soapy water and wipe dry.
3. Remove backing from new label and carefully apply label over old label.
NOTICE: DO NOT ATTEMPT TO REMOVE OR LOOSEN THE NEW LABEL ONCE IT HAS BEEN APPLIED AS THIS WILL DEFACE THE LABEL.
If you install the new label, rather than asking your dealer to do it, please tell us by signing and returning the postage-paid pre-addressed reply card. If you have sold, traded, or disposed of your vehicle, please fill out the information requested on the reply card and return it to us. This will assist us in assuring that all affected vehicles have been corrected and will eliminate the necessity for bothering you with follow-up notifications.
Should you choose to have a Buick Dealer install the label, please contact your dealer to arrange a mutually satisfactory service date to have this modification performed. Take the enclosed label with you. Please allow additional time for the dealer to process your vehicle.
We are sorry to cause you this inconvenience; however, we have taken this action in the interest of your continued satisfaction with our products.