Rear Brakes With Electronic Parking Brake Assembly Overview

Rear Brakes with Electronic Parking Brake Assembly Overview

Rear wheel brake with automatic adjustment.

• Only install the complete repair kit.






1 - Self-locking bolt

• 12 Nm

2 - Electromechanical parking brake actuator

• Electromechanical parking brake control module, refer to => [ Electro-Mechanical Parking Brake Control Module ] Service and Repair

• Actuator, removing and installing, refer to => [ Electro-Mechanical Parking Brake Actuator ] Service and Repair

3 - Seal

• Always replace

4 - Self-locking bolt

• 35 Nm

• Always replace

• When loosening and tightening, counter-hold at guide pin

5 - Spacer

6 - Brake hose

• To brake caliper, 12 Nm

• Do not disconnect brake line when changing brake pads

• Make sure that retaining tabs are seated correctly in bracket.

• Do not twist it when installing

7 - Brake caliper housing

• Do not remove brake hose when replacing brake pad

• Brake caliper, servicing

• It is possible to install brake carrier with brake caliper

• Removing and Installing, refer to => [ Rear Brake Caliper with Brake Carrier ] Rear Brake Caliper With Brake Carrier

• Replace, refer to => [ Rear Brake Caliper, Replacing ] Rear Brake Caliper, Replacing

8 - Brake carrier with guide pins and protective cap

• Supplied as pre-assembled replacement part with sufficient grease on guide pins

• If protective caps or guide pins are damaged, install repair kit. Use grease packet supplied to lubricate guide pins

• it is possible to install brake carrier with brake caliper

• Removing and Installing, refer to => [ Rear Brake Caliper with Brake Carrier ] Rear Brake Caliper With Brake Carrier

9 - Brake pads

• Wear limit, refer to => [ Brakes ] [1][2]Specifications

• Must always be replaced together on both sides of axle

• Removing and Installing, refer to => [ Rear Brake Pads ] Rear Brake Pads

• It is possible to install brake carrier with brake caliper

• The brake pads must be seated between both securing tabs on the pad retaining plate to provide the air gap between the brake disc and brake pad.

10 - Anti-rattle spring

• Always replace when pads are replaced

• The brake pads must be seated between both securing tabs on the pad retaining plate to provide the air gap between the brake disc and brake pad.

11 - Wheel Bolts

• Mounting wheels

• 140 Nm

12 - Bolt

• 5 Nm

13 - Brake disc

• Wear limit, refer to => [ Brakes ] [1][2]Specifications

• Removing and Installing, refer to => [ Rear Brake Disc ] Rear Brake Disc

• Must always be replaced together on both sides of axle

• Brake disc allocation, refer to => [ Brakes ] [1][2]Specifications

14 - Hex head bolts

• 10 Nm

15 - Brake shield

• Removing and Installing, refer to => [ Rear Brake Shield ] Rear Brake Shield

16 - Bolt

• 100 Nm plus an additional 90° turn

• Replace

17 - Bolts

• 100 Nm plus an additional 90° turn

• Replace