Rear Brake Caliper Assembly Overview

Rear Brake Caliper Assembly Overview

• Applies to steel and ceramic brakes.

• When servicing, completely install repair set.

• Apply thin coat of assembly paste to brake cylinders, pistons and seals.






1 - Bolt

• Self-locking

• Torque specification: 35 Nm

• Always replace

• When loosening and tightening, counter-hold at guide pin.

2 - Brake Caliper with Actuator

• Brake caliper is not designed to be disconnect from actuator.

• Pre-bleed caliper housing after repairing. Refer to => [ Brake System, Bleeding ] Brake System, Bleeding

3 - Bleeder Valve

4 - Dust Cap

• Push onto bleed valve.

5 - Seal

• Removing and installing, refer to => [ Rear Brake Caliper Piston ] Rear Brake Caliper Piston.

6 - Pressure Nut

• To operate parking brake.

7 - Pistons

• Removing and installing, refer to => [ Rear Brake Caliper Piston ] Rear Brake Caliper Piston.

8 - Guide Pins

• Grease before pulling on protective cap.

9 - Protective Cap

• Pull onto brake carrier and guide pin.

10 - Brake Carrier with Guide Pins and Protective Cap

• Supplied as an assembled replacement part with sufficient grease on guide pins.

• If protective caps or guide pins are damaged, install repair kit. Use supplied grease packet to lubricate guide pins.

11 - Protective Cap

• Removing and installing, refer to => [ Rear Brake Caliper Piston ] Rear Brake Caliper Piston.

• Pull onto piston with outer sealing lip.