Corrugated Line

Corrugated Line

• Corrugated lines can be replaced with heat shrink sleeves.

Special tools, testers and auxiliary items required

• Hot Air Gun (VAS 1978/14A) from the Wiring Harness Repair Set (VAS 1978 B).

• Air Hose Pliers (VAS 6228)

• Connecting piece (1J0 955 875 R)

• Connecting piece (1J0 955 875)

Procedure





- Cut out the damaged part of the washer fluid line with the (VAS 6228).

- Connect the ends - 1 and 4 - of the washer fluid line with connector pieces - 2 and 3 -.

- Slide the heat shrink sleeve - 5 - over an end of the washer fluid line and connect the connector pieces with each other.

- Slide the heat shrink sleeve over the washer fluid connector pieces.

- After sliding on, the heat shrink sleeve must be shrunk using the (VAS 1978/14A).

• The heat shrink sleeve must be heated from the center outward until it seals completely.

• Set the (VAS 1978/14A) to the correct temperature according to the operating instructions.

• When shrinking, ensure no other lines, plastic parts or insulation material is damaged by the hot nozzle.

- Check for function and leaks.