Upper Intake Manifold Assembly Overview

Upper Intake Manifold Assembly Overview





1 Intake Manifold Tuning (IMT) valve position sensor (G513)

2 2.5 Nm

3 2.5 Nm

4 Actuator for intake manifold change over

• Installed location of tooth segments for variable intake manifold => [ Installed Location of Tooth Segments for Variable Intake Manifold ]

• As replacement part together with - 24 -

5 Seal

• Replace if damaged

• Lift out with screwdriver to replace

• Press in by hand

6 Ball pin, 2.5 Nm

7 Intake manifold, upper

• Removing and installing => [ Upper Intake Manifold ] Upper Intake Manifold.

8 Throttle valve control module (J338)

9 5 Nm

10 Wire harness retainer

11 Seal

• Replace

12 Intake Manifold Runner Control (IMRC) valve (N316)

13 2.5 Nm

14 Intake Air Temperature (IAT) sensor (G42)/Manifold Absolute Pressure (MAP) sensor (G71)

15 O-ring

• Replace

16 2.5 Nm

17 Crankcase housing ventilation pressure regulator valve

18 O-ring

• Replace

19 6 Nm

20 Washer

21 Sleeve

22 Seals

• Replace

23 Seal

• Replace if damaged

• Lift out with screwdriver to replace

• Press in by hand

24 Lever with tooth segment

• For variable intake manifold

• Installed location of tooth segments => [ Installed Location of Tooth Segments for Variable
Intake Manifold ]

• As replacement part together with - 4 -

25 Seal

• Replace if damaged

• Lift out with screwdriver to replace

• Press in by hand

26 Change over valve for intake manifold flap (N239)

Installed Location of Tooth Segments for Variable Intake Manifold





• The lower edges of tooth segments must be flush with one another - arrows -.