Rear Door Window Glass: Adjustments

Rear Door Window, Adjusting

To help check the adjustment, distance - a - (9 mm, or 0.354 in.) can be marked on the window along the B-pillar using a water-soluble pen.







- Install door window onto window regulator.
- Run door window upward until almost at top stop.
Door window - 1 - and seal - 4 - for door component carrier must be parallel with each another in the roof and C-pillar areas.
- Press door window - 1 - toward B-pillar - 3 -.

NOTE: The edge of door window - 1 - must run 9 mm (0.354 in.) (distance - a -) inside seal - 4 - for door component carrier - 3 -.

- Tighten bolts at window regulator mount.
Tightening torque: 2.5 Nm (22 in.lb)
- Run window - 1 - up to top stop.
- Check distance - a - and wipe off marking.