Backrest Adjustment Motor (Power Seat With Memory), Removing and Installing

Backrest Adjustment Motor (Power Seat With Memory), Removing And Installing







Removing
- Removing seat.
- Remove outer side panel of seat
- Remove backrest cover panel

NOTE: For greater clarity, the backrest is shown without the seat

- Remove nut from backrest adjustment motor Fig. 1.
- Using a screwdriver, pry off spring washer - 5 - on same side as motor (inset - B - in illustration)
- Using a hammer and punch, knock shaft - 4 - through one side of backrest frame.







- Pull shaft out of backrest frame - 1 - until backrest adjustment motor can be removed.

Installing
- If a new backrest adjustment motor is being installed, align teeth in motor with splines on shaft Fig. 2.
- Push shaft - 4 - through backrest adjustment motor and through backrest frame - 1 -.
- Place seat on its side.
- Place a wooden block - 2 - under shaft - 4 - (inset - A - in illustration)
- Using an 11 mm socket, knock spring washer - 5 - onto shaft - 4 - (inset - C - in illustration)
- Install nut onto backrest adjustment motor and connect wiring.







- A wiring adapter will be required; the type of adapter depends on the installation layout.
- After installing seat in vehicle, perform basic setting of backrest and seat

1 - Backrest
2 - Wooden block
3 - Socket (11 mm)
4 - Shaft
5 - Spring washer







Fig. 1 Detaching mounts for backrest adjustment motor

- Disconnect connector - 5 -.
- Pull backrest cover - 3 - and damper felt - 2 - to one side.
- A wiring adapter will be required; the type of adapter depends on the adjustment motor installed.
- Remove nut - 4 -.







Fig. 2 Preparing backrest adjustment motor

- Using a screwdriver, turn asymmetric section of teeth - 1 - to align with shaft in backrest frame.