Sedan

LATCH System, "Lower Anchor And Tethers For CHildren" (Sedan), Assembly Overview

Rear upper tethers







NOTE: Mounts can be installed for three child seat attachment points.

1 - Pop rivet
- 3 per plate
- To secure thread washer -2- on metal mounting

WARNING: Threaded plate must always be installed from below (luggage compartment side).

2 - Threaded plate
- Threaded insert points upward
3 - Concealment cap
- For installation, position at rear and press down at front (symbol points forward).
4 - Bolt
- Tightening torque: 23 Nm
5 - Attachment point
6 - Spacer sleeve

Rear lower anchors







1 - Rear lower anchor bracket
- Remove bolts -2- (2x).
2 - Bolts (4x)
- 30 Nm (22 ft lb)
- Mount rear lower anchor bar -1- with bolts -2- fastened into threaded holes in body floor panel.

NOTE:
- To install solid rear backrest, push tabs behind rear lower anchor bracket.
- If rear lower anchor is retrofitted, it may be necessary to flatten tab in vise down to about 3 mm
- When installing, make sure there is adequate clearance to the lap belt retractor. If necessary, rotate the lap belt retractor.