087 Transmissions/5- Cylinder Engines
087 TRANSMISSIONS/5.CYLINDER ENGINESInstalling
^ Install drive plate along with disc 1 and 3.0 mm shim 2
^ index mark (arrow) on disc 1 must face torque converter
^ disc 1, Part No. 035 105 301A
^ shim 2, Part No. 035 105 303A
CAUTION
Part numbers are for reference only. Always check with your Parts Department for latest information.
^ tighten drive plate, only to 30 Nm (22 ft lb), before checking/adjusting
CHECKING/ADJUSTING
^ find measurement A, (i.e. inside clearance, drive plate)
^ find measurement B, (i.e. average distance from drive plate to cylinder block, measured at three different sites along circumference)
^ calculate test measurement:
measurement B (outside dimension)
measurement A (inside dimension)
must be 17.2-18.8 mm
If NO
^ remove drive plate
^ remove shim 2
After checking/adjusting
^ use locking compound on drive plate bolts at crankshaft
^ tighten drive plate to 60 Nm (44 ft lb) plus 1/4 turn (900)
NOTE
Revised tightening torques for 5- and 6-cylinder engines (mounted to compatible transmissions) are illustrated in "Engine/Transmission, Mounting".