A/T Clutch Pressure Control Solenoid Valve C Replacement

A/T Clutch Pressure Control Solenoid Valve C Replacement

1. Do the battery removal procedure. Removal and Replacement

2. Remove the air cleaner. Service and Repair

3. Remove the battery base.

4. Disconnect the A/T clutch pressure control solenoid valve C connector.

5. Remove A/T clutch pressure control solenoid valve C.

6. Remove the ATF joint pipes, O-rings, ATF pipe, and gasket.

7. Clean the mounting surfaces and the fluid passages of the solenoid valve body and transmission housing.






8. Install the 8 x 53 mm ATF joint pipe (A) with the filter end into its mounting hole (B).






9. Check the height (A) of the 8 x 53 mm ATF joint pipe (B) between the top (C) of the pipe and solenoid valve body mounting surface (D). The height is about 7 mm (0.3 in.) If the height is over 7 mm (0.3 in.), push the pipe until it bottoms in the accumulator body.






10. Install the new gasket (A) on the transmission housing, and install the 8 x 34.5 mm ATF joint pipe (B) with the filter end into the transmission housing and 8 x 25.2 mm ATF pipe (D).

11. Install new O-rings (E) over the ATF joint pipes.

12. Install A/T clutch pressure control solenoid valve C.

13. Check the connector for rust, dirt, or oil, then connect the connector securely.

14. Install the air cleaner. Service and Repair

15. Install the battery base.

16. Do the battery installation procedure. Removal and Replacement