Failure Mode J

Mode J: Blown SRS No.22 fuse, or open in the wire.


CAUTION: Disconnect the battery negative cable, then disconnect the positive cable. Install the short connectors on both airbags - refer to "Indicator Light Troubleshooting", caution notice.

NOTE: Check the SRS No.22 (20A) fuse in the dash fuse box before testing.

1. Connect Test Harness B between the SRS unit and SRS main harness 18-P connector.

2. Reconnect the positive and negative cables to the battery.

3. Measure the voltage between the B13 terminal and body ground with the ignition switch ON.






- If there is battery voltage, the SRS unit is faulty. Replace and recheck the voltages according to the chart in the "Indicator Stays On Continuously" procedure.

- If less than battery voltage, the main harness is faulty. Replace the SRS main wire harness and recheck the voltages according to the chart in the "Indicator Stays On Continuously" procedure.